Chapin Tree/Turf Pro 62000 Manuel D'utilisation Et D'entretien page 11

DISASSEMBLING AND REPAIRING THE SHUT OFF VALVE
Figure 1
Locking
Clip
A
Figure 2
Valve
Stem
B
C
Figure 3
1) Assembled shut-off valve (Figure 1).
2) Remove the retaining pin (A) (Figure 2) place the notched
end of the retaining pin on a hard surface and push down.
Remove the retaining pin and slide the handle off the valve.
3) Remove the retaining nut (o-ring attached), spring, and valve
stem (B) (Figure 3). Replace worn parts. Lubricate the O-rings and
reassemble by reversing the steps above. Place the handle groove in
the slotted area of the valve stem and make sure the locking clip is
positioned in the neutral position (see "Helpful Spraying Information"
section). Insert the retaining pin. Push down on the handle a few times
to distribute the lubricant evenly. Check filter (C) in end of shut-off
valve for debris. Remove filter and flush with water to clean out.
10E