Silverline 267412 Mode D'emploi page 8

GB
Troubleshooting
Problem
Screw is driven too deep into
the workpiece
Screw head is not driven fully
into the workpiece
Screw belt isn't feeding
correctly
Screw not lined up with material
Screw head getting damaged
Not driving screws correctly
Cannot use the first screw on
the belt
Screw driven into material at
an angle
Mechanism stiff to operate
Difficult to adjust for screw
length
Other abnormal operation
8
All manuals and user guides at all-guides.com
Possible cause
Depth Adjuster (9) incorrectly set
Depth Adjuster incorrectly set
Incorrect operation
Belt damaged
Incorrectly fitted belt
Screw Belt Feeder (8) is not allowing free
movement of belt
Screw Length incorrectly set
Drill at too high a speed
Non-compatible collated screw belts
Mechanism moves to next screw when plunged
Screw Length incorrect
Mechanism requires lubrication
Screwdriver bit is slightly too large for Screwdriver
Bit Eye (4)
Mechanism can be stiff
Possible mechanism fault
Solution
Move the Depth Adjuster up to reduce the depth
Move the Depth Adjuster down to increase screw depth
Plunge the mechanism fully so it is stopped by the Depth Adjuster
Move past damaged part of belt
Make sure belt is correctly fitted at the loading point
Check Screw Belt Feeder is not damaged or bent, clean any rough
edges if necessary
Adjust as per instructions
Adjust to lowest speed setting and manually control trigger so speed is
lower for loading screw onto bit
Only use compatible collated screws (see Specification)
Normal operation
Adjust Screw Length Knob (2) so Stopper Base (7) holds full length
of screw
Carefully lubricate as per instructions
Run tool until the bit rotates easily in the eye
Apply a small amount of oil or grease
May require repair or replacement