Armlift Height; Operation Settings; ( Led Color Setting / Reverse Playback Setting / 78 Rpm Setting / Torque Setting / Brake Setting) - Panasonic Technics SL-1200MK7 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Armlift height

Make an adjustment according to your
cartridge if necessary.
Preparation
 Put a record on the turntable.
 Remove the stylus cover, taking care not
to damage the stylus, then release the arm
clamp.
 Lift the cue lever and move the tone arm over
the record.
1
Check the armlift height (distance
between the stylus tip and record
surface).
If adjustment is needed, go to
step 2 .
 The armlift height is factory-adjusted to
8 to 13 mm.
2
Return the tone arm to the arm
rest and fix it with the arm clamp.
Turn the adjustment screw.
 Turning the screw clockwise lowers the
armlift.
 Turning the screw anti-clockwise raises
the armlift.
Armlift
Allows for LED color setting, reverse playback
setting, 78 rpm setting, torque setting and brake
setting.
①Turn the unit off and pull out the power plug.
② Adjust as desired by setting the switches with
a fine Phillips head screwdriver and the like.
Switch no.
Allows you to select red or blue for the color of the
strobe light, speed select buttons, pitch range select
button and RESET LED lamp.
Red
Blue
Allows you to disable or enable reverse playback. ( 19)
REV disabled
REV enabled
Allows you to disable or enable 78 rpm. ( 19)
78 rpm disabled
78 rpm enabled
Allows you to select from four levels of strength to
adjust the torque.
High ①
Armlift
screw
Low ④
Arm clamp
Allows you to select from four levels of brake strength
to stop the turntable after [START-STOP] is pressed.
High ①
Low ④

Operation settings

ON
ON
OFF
1
2
3
4
5
6
7
8
LED color setting
Switch no.: 1 (LED)
OFF (Factory setting)
ON
Reverse playback setting
Switch no.: 3 (REV)
OFF (Factory setting)
ON
78 rpm setting
Switch no.: 4 (78)
OFF (Factory setting)
ON
Torque setting
Switch no.: 5 (TQ1)
ON
OFF
③ OFF (Factory setting) OFF (Factory setting)
ON
Brake setting
Switch no.: 7 (BK1)
OFF
② OFF (Factory setting) OFF (Factory setting)
ON
ON
Switch no.: 6 (TQ2)
ON
ON
OFF
Switch no.: 8 (BK2)
ON
OFF
ON
17
(17)
English

Publicité

Chapitres

Table des Matières
loading

Table des Matières