Targus Stow-N-Go Mode D'emploi page 7

Targus Stow-N-Go
•
The operation system identifies the receiver, prompts "USB
Human Interface Device" and begins installation automatically.
Please follow the instruction on the screen to complete the
installation procedure.
Establishing a Communication Link
This remote is a plug-n-play device. It should be operating once the
USB receiver is connected and recognized by the computer.
•
If the remote is not working or you have recently replaced the
battery, you can try to reset the ID code between the receiver and
the remote. To do this, do the following:
Press and release the connection button on the receiver. The LED
should glow red. Next, locate and keep pressing the connection button
on the back of the remote until the Link Indicator starts blinking. Now
the remote controller has re-linked with the USB receiver.
NOTE: Make sure that your computer is turned on and has detected he
USB receiver before you set the ID code.
Now, you can launch your media player to confirm that the remote is
functioning properly.
All manuals and user guides at all-guides.com
TM
Media Remote Control Card
6
connection
button
connection
button
Link
Indicator