ZeKat EG-IoT K016 Notice D'installation page 8

 Without the Ease_EG_IoT_Config Tool using a terminal emulation software
as for example 'HyperTerminal' (With 155 200 bauds, 8 bits, without parity, 1
stop)
1 - Enter the 'B' character (Reset estimated remaining battery capacity). Then
answer the different questions on the terminal to update the estimated
capacity of the battery.
2 - Enter the new date by sending the '1' character and the new time in UTC
(Universal Time Coordinated) by sending the '2' character .
3 - Send the 'E' character to record the new date and time .
 Disconnect the cable and close the equipment
Be careful not to crimp the battery wires when
closing the casing.
Check the presence of the O-rings under
the screw heads before replacing them
on the housing.
Tightening torque shall be 0.6N.m to ensure the sealing (Automatic
Screwdriver prohibited).
Inverser le pliage pour la version française.
The information and non contractual pictures in this document are given for indication purposes
only. ercogener SAS reserves the right to modify its products and documentation at any time.
EG-IoT_K016_IS_000
Dct_425_01