Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
ATTACH MOUNTING SYSTEM TO SNOW THROWER
INSTALL THE MOUNTING POST CLAMPS (FIG. 1)
1. Insert two U-bolts [O] around the snow thrower frame and through
the mounting post clamp spacer [N] and the mounting post
clamp [M] as shown. (Fig. 1)
Note: Exact positioning may vary depending on manufacture.
2. Install two Nylock nuts [P] to each U-bolt [O]. Snug but do not fully
tighten. Leave Nylock nuts [P] loose for final adjustments of the mounting
posts. (Figs. 1 and 1a)
Note: In some instances, it may be necessary to mount the top
U-bolts [O] above the handlebar crossbar support. (Fig. 1a)
This will help the assembled cab sit higher for added clearance.
3. Repeat on other side.
INSTALL THE LOWER MOUNTING POSTS (FIG. 2)
4. Insert lower mounting posts [L] into mounting post
clamps [M] as shown. Snug but do not fully tighten.
Leave the nuts loose, but do not remove, for final
adjustments of the mounting posts. (Fig. 2)
5. Repeat on other side.
CAUTION: Position of the clamps may vary
depending on snow thrower manufacturer.
CAUTION: Make sure no cables or wires
are trapped or pinched.
WARNING: Make sure nothing interferes with the
safe operation of your snow thrower.
All manuals and user guides at all-guides.com
N
M
2X
P
2X
6
Snow thrower
handlebar upright
O
OPTIONAL MOUNTING METHOD
Top U-bolt [O] may need to be on
top of handlebar crossbar, if the
Fig. 1
mounting bar needs clearance for
your snow thrower controls.
Fig. 2
L
O
O
Fig. 1a
Publicité
