Inateck P6 Mode D'emploi page 3

1. Connect Inateck P6 with computer via USB cable
2. Power on Inateck P6 by toggling switch from OFF to ON and short press the
trigger. Inateck P6 will continuously beep. Beep stops after successful connection.
3. Open a file on computer and move cursor to the blank where scanning output
should be placed. Scanning results can be displayed on computer then.
Function Setup
(Note: The barcode marked by "*"means default setting of Inateck P6.)
Users must read setup barcodes in order to change the default settings in Inateck P6
Barcode Scanner.
Status indication
Buzzer Indication
Beeping Meaning
One short high note（100ms） Read barcode successfully
One short high note（20ms） Data upload from scanner to Computer
One long high note（400ms） Wrong Setup （on setup status, blue LED stays on）
Invalid scanning due to full buffer (Scanned barcode not saved.)
Pairing Failure (Occurs only during the pairing process)
Two or more long high tones（800ms） USB being configured（It happens when USB cable is inserted）
Three chord sounds Enter setup mode（Blue LED on）
Exit setup mode（Blue LED off）
Two short notes（tone from low to high） Correct Setup
Two short beeps (tone from high to low) The connection between Inateck P6 and computer is disrupted.
LED Indication
Indicator color Meaning
Green LED flashes once (LED2) Barcode successfully read and uploaded to computer
Blue LED flashes once (LED2) Barcode successfully read and saved in buffer, but not uploaded to computer
Blue LED stays on (LED2) Inateck P6 scanner on setup status
Yellow LED blinks（light/shade ratio0.5s : Low battery
0.5s） (LED1)
Red LED stays on (LED1) Inateck P6 scanner in charge (Red LED off when battery is full)
EN EN
Scan"Enter setup"barcode;
Change scanner setting by
scanning certain function
setup barcode;
Scan "Exit with save" barcode
to finish the setup.
3
Frequently Used Barcodes
Enter Setup
Exit without Save
（*）Apply Enter for Suffix
（*）Enable Auto Laser-darkening Mode
Enable Continuous Scanning Mode
（*）Enable Auto-sleep Mode
2.4G Paring
Upper case for all letters
Mute
4
(*)Medium Volume
Exit with Save
Restore Factory Setting
Do Not Apply Enter for Suffix
Enable Manual Scanning Mode
Enable Auto Induction Mode
Disable Auto-sleep Mode
Lower case for all letters
（*）Keep original case
Minimum Volume
Maximum Volume