Preliminary Operations; Inserting The Batteries - ohmex SEW 7050 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SEW 7050

PRELIMINARY OPERATIONS

Mains power supply connection (27):
Connect the plug (27a) to the socket (27b) on the motor body and then connect the
power supply (27) to the power socket (Fig. F2).
Foot switch connection (26):
Connect the plug (26a) of the foot switch (26) to the socket (26b) on the motor body
(Fig. F3).
Place the pedal (26) on the floor.
> > Inserting the batteries
You can use the appliance with 4 AA batteries.
To avoid an accidental start of the appliance, make sure that the
selector (7) is in the "OFF" position (appliance off).
To insert or replace the batteries:
1. Remove the battery slot cover from the remote control rear part.
2. Insert the batteries (4 AA batteries).
RESPECT THE POLARITIES!
3. Reposition the battery slot cover.
Batteries must not be exposed to excessive heat such as sun rays, flames or
similar.
Batteries must be kept out of the reach of children.
If they're handled in the wrong way they could cause fires or
chemical burns.
Do not expose the batteries to temperatures higher than 100° C.
Do not charge or disassemble the batteries.
EN
63

Publicité

Table des Matières
loading

Table des Matières