Assembly and operating instructions for an
exhaust air controller Model AS-6030.3
(radio version)
Thank you for purchasing the PROTECTOR
AS-6030.3 Exhaust Air Controller.
INTRODUCTION
This device can be used as an exhaust air control device,
as an aid to monitor fresh air supply when commissioning
an exhaust air device (fume extractor hood, fan etc...).This
cannot replace self-monitoring to ensure fresh air supply,
but it can be supportive. When the furnace is active (hot
stovepipe) this device only activates the exhaust air system
in the event of pressure equalisation when a window or door
is opened. The additional fresh air streaming in can thus be
drawn in from the outside.
GENERAL
This device can be used as an exhaust air control device,
as an aid to monitor fresh air supply when commissioning
an exhaust air device (fume extractor hood, fan etc...).This
cannot replace self-monitoring to ensure fresh air supply,
but it can be supportive. When the furnace is active (hot
stovepipe) this device only activates the exhaust air system
in the event of pressure equalisation when a window or door
is opened. The additional fresh air streaming in can thus be
drawn in from the outside.
ATTENTION: When using this device for exhaust air control,
the shutter must be open to ensure adequate inflow of
fresh air!
KEY
1 AS-6030.3 Receiver
2 Code button Test/Coding
3 LED Status
4 Window transmitter
5 LED Status
6 Magnet for window transmitter
U Washers
7 Furnace transmitter
8 Thermo-sensor
9 Status button Furnace transmitter
10 LED Furnace hot
11 LED Furnace cold
12 Battery compartment lid
13. Exhaust pipe
14. Feedthrough hole (4 mm)
15. Fastening holes (2 mm)
H Holder
USE OF ADDITIONAL TRANSMITTERS (MAX. 8 ITEMS)
The device can be extended by multiple window transmitters
and furnace transmitters, whereby the extractor hood is
no longer bound to an individual window or furnace. Each
individual window transmitter can enable the exhaust unit
and each individual furnace transmitter can disable the
exhaust unit.
17
ENGLISH | AS-6030