Bushnell Engage SENDX2680A Mode D'emploi page 3

Thank you for purchasing your new Bushnell® Engage™ Spotting Scope.
This manual will help you optimize your viewing experience by explaining how to utilize the scope's controls and features,
and how to care for it. Read the instructions carefully before using your scope.
A
PARTS GUIDE
TRIPOD MOUNTING
Your Engage spotting scope should be mounted on a high quality, stable tripod (not included) to ensure safe operation
and a vibration-free viewing experience. Attach the scope's mounting base to the screw on the tripod's platform, so that the
scope is held securely in place and provides a level view (adjust tripod as needed). The tripod mounting base can be rotated
by loosening the small "B" logo knob on one side, above the mount (see photo below).
(D)
Tripod Mounting Ring/Base
USING THE ZOOM EYEPIECE AND FOCUSING
Rotate the zoom ring (B) on the eyepiece to change magnifying power from low to high. Lower power settings will provide a
brighter image with a wider fi eld of view; higher powers allow observing smaller details on more distant subjects. Note: the
zoom eyepiece is not interchangeable. Do not attempt to remove it from the scope.Turn the focus knob in either direction
until your subject appears as sharp as possible. To reduce the need to readjust focus when zooming, set the zoom to its
highest power and focus on your subject. When you zoom back down to lower powers, it will stay in focus.
NEVER LOOK DIRECTLY AT THE SUN WITH YOUR SPOTTING SCOPE,
AS IT MAY CAUSE SERIOUS DAMAGE TO YOUR EYES
B
D
G
A Twist-Up Eyecup
B Zoom Ring
C Focus Knob
C
D Tripod Mounting Ring/Base
E Objective Lens
F Sliding Sunshade
G Picatinny Accessory Rails
Loosen knob to rotate mounting ring
F
ENGLISH
E
3