Samsung DMT210 Manuel D'utilisation page 25

InformatIon coDES
Information codes are displayed to help you better understand what is occurring with your dishwasher.
If your dishwasher have any problem, below CODE SYMBOL light(s) is(are) blinked.
If you see any of the codes below, select the Cancel and Drain option, and then follow the directions under
Solution.
COde SymbOl
For any codes not listed above, call 1-800-SAMSUNG (1-800-726-7864).
DMT300-00062A .indb 25
meANING SOlUTION
Temperature Sensor
error
Functional error. With the dishwasher empty, add
Heater error
detergent, and then run a cycle.
If the problem continues, go to your house circuit
breaker panel, set the dishwasher's circuit breaker
High temperature
switch to off, and then contact an authorized
Heating error.
Samsung service center.
Low-level water error
Check whether the water supply valve is closed, the
water supply is suspended or the water inlet valve or
line is frozen or clogged by foreign particles.
Water supply error
If the problem continues, close the water supply
valve, and then contact an authorized Samsung
service center.
Check the temperature of the supplied water. If it
High temperature
is higher than 176 ˚F (80 ˚C), a functional error may
Water supply error
occur with the dishwasher.
Check whether the drain hose is clogged or folded. If
the problem continues, close the water supply valve,
Drain error
and then contact an authorized Samsung service
center.
Over-level water error
Functional error. Close the water supply valve and
go to your house circuit breaker panel, set the
dishwasher's circuit breaker switch to off, and then
contact an authorized Samsung service center.
Leakage error
Functional error. Turn off the dishwasher and try to
start it again.
Button error
If the problem continues, contact an authorized
Samsung service center.
Functional error. Make sure to close the door
Door open warning properly. If the problem continues, contact an
authorized Samsung service center.
troubleshooting _25
2010-08-09 11:17:52