Aquacontrol Exclusiv 2,4 Mode D'emploi page 66

1 Introduction
The salt electrolysis cell has a capacity of 15 g/h at a salt concentration of 0.4%
(4000ppm).
The device is suitable for outdoor pools up to 65m³.
When the desired chlorine concentration (redox in mV) is reached, the chlorine
production switches off automatically.
Please observe:
Before commissioning/installation, it must be checked whether all
components used in the swimming pool are resistant to salt water or suitable
for the operation of a salt electrolysis system.
The manufacturer is not responsible for any damage that may occur.
Even with a low salt content, the water can have a corrosive effect.
2 Indications on the display
Indications for disinfection (redox):
➔ STBY – Standby
• No chlorine production, the setpoint is reached.
• INIT – Initialisation phase
• Transition from RUN+ to RUN- (polarisation change of the electrolysis cell)
➔ RUN+ / RUN-
• Electrolysis is active. Positive or negative polarity.
66