Publicité
Step 4
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A)
å
until the shoulders of the SCREWS rest on the surfaces of the ENDS.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (C) onto the ENDS (A). Line up the grooves
å
in the MOLDINGS over the heads of the SCREWS in the ENDS.
NOTE: If the MOLDINGS come up off of the SCREWS, remove them
å
and slide them on again.
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
C
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Page 8
These edges
should be even.
A
32S
A
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Shoulder
419961
These edges
should be even.
C
www.sauder.com/services
Publicité
