Clean Air Optima CA-606W Mode D'emploi page 5

Operating instructions
®
Before getting started, remove the Clean Air Optima CA-606W from its box and allow
it to become accustomed to the room temperature for at least 30 minutes especially if
the machine is cold from the outside air. Place the device on a solid, level and front water-
insensitive surface, approx. 60 cm from the floor and at least 20 cm from the wall.
The CA-606W is designed to operate at temperatures between 5 -40 ºC and relative humidity
of less than 80%.
To get started, grasp the water tank by the handle at the top and lift from the base. Next, flip
the tank over and unscrew and remove the water tank lid and filter.
Handle
Water tank lid and filter Faucet for filling
Then place the water tank under the faucet for filling, grasping it from the handle under the
water tank. Fill the tank with tap water (or other clean water source with water temperature
under 40ºC), re-insert the lid and filter. Flip the water tank once again until it is on the right side
up. Ensure that the basin is clean and then carefully place the water tank back on the lower
body.
Wait a few seconds until the water tank lid starts to release water into the basin. You will hear
a bubbling sound as the air enters the water tank. Plug the power plug into a suitable power
outlet, a signal sounds to indicate that your device is in standby mode. If the humidifier is
switched on/off, the value for humidity will now be displayed.
5