Nicols PAR LED 1210 FC Manuel D'utilisation page 25

LED display
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select
always on) or
ENTER button to setup or exit menu mode without any change after 7seconds. Back to the
functions without any change press MENU button again.
Display Inverse
Press MENU button until
select (display normal) or
Back to the functions without any change press MENU button.
White Balance
Press the MENU button up to when the
button, and use DOWN and UP button to select
button to confirm and use DOWN and UP button to adjust the value between 125 and 255,
once select press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the last function without any change press the MENU
button.
Manual setting color
Press the MENU button up to when the
button, and use DOWN and UP button to select
(strobe), press ENTER button to confirm and use DOWN and UP button to adjust the value,
once select press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the last function without any change press the MENU
button.
Self-Test
Press the MENU button up to when the
ENTER button and the unit will run the built-in programmer for self-test. To go back to the
functions press the MENU button.
(display off 20 seconds after exit menu) mode. Once select, press
is blinking on the display. Use DOWN and UP button to
is shown on the display. Pressing ENTER
(display inverse), press ENTER button to setup.
is shown on the display. Pressing ENTER
,
is shown on the display. Pressing ENTER
is blinking on the display. Pressing the
24 -
or , press ENTER
or ... or
,
(display