button and the display will blink. Use the DOWN and UP buttons to select the
(Dimmer Mode 1: Optically Linear) or
(Dimmer mode 2: Square Law) or
(Dimmer mode 3: Inverse Square Law) or
(Dimmer mode 4: S-cure) mode. Once
the mode has been selected, press the ENTER button to setup or automatically return to the
main functions without any change after one minute. To go back to the functions without any
change press the MENU button again.
Optically Linear: The increase in light intensity appears to be linear as DMX value is
increased.
Square Law: Light intensity control is finer at low levels and coarser at high levels.
Inverse Square Law: Light intensity control is coarser at low levels and finger at high levels.
S-cure: Light intensity control is finger at low levels and high levels and coarser at medium
levels.
Sound mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button, Use DOWN and UP button to select the
(sound on) or
(sound off).
Once select, press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the functions without any change press the MENU
button
Blackout mode
Press the MENU button up to when the
is shown on the display. Pressing ENTER
button, Use DOWN and UP button to select the
(blackout) or
(normal).
Once select, press ENTER button to setup or automatically exit menu mode without any
change after 7seconds. To go back to the functions without any change press the MENU
button
23 -