Publicité
Les langues disponibles
Les langues disponibles
DVC-35IP INTERMITTENT PILOT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. T h i s a p p l i a n c e i s e q u i p p e d w i t h a n i g n i -
tion device which automatically lights the pilot.
Do NOT try to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's
phone, Follow the gas supplier's instructions.
1. STOP! Read safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
GAS FLOW
HONEYWELL IP SMART VALVE
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
12430-12-0709
causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
OFF ON
GAS VALVE SHOWN IN OFF POSITION
TO TURN OFF GAS TO APPLIANCE
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it; call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
5. Remove front panel door.
6. Slide gas control switch to "OFF."
7. Wait ten (10) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas, STOP!
Follow "B" in the safety information above. If you don't
smell gas, go to the next step.
8. Slide gas control switch to "ON."
9. Replace front panel door.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions,
"TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
3. Remove front panel door.
4. Slide gas control switch to "OFF."
5. Replace front panel door.
Page 13
Publicité
