Publicité
Les langues disponibles
Les langues disponibles
1. Ensure the base and walls are leveled. Place the metal track (B) approximately as "C" from the edge of the
base to the center of the metal track. Ensure the metal track (B) is leveled, then mark the holes clearly on the
wall.
2. Remove track and drill pilot holes in the marked locations with a Φ8mm (5/16in) drill bit.
3. Insert the wall anchors (AA) using a rubber mallet until the wall anchors are flush with the wall.
4. Replace and secure the metal track (B) with screws (BB). Do not overtighten.
WALL TRACK INSTALLATION
C=32 for Sierra 48
C=23 for Sierra 60
Helpful Hint
Make sure there
is a support stud
located behind the
drywall, behind the
tracks!
C
Helpful Hint
Do not overtighten!
This may crack the
acrylic or tile walls.
9
1
B
2
Φ 8mm
5/16in
3
AA
4
BB
Publicité
