Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The control switch cannot be
pressed, or is stuck.
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
Product or battery gets very
warm.
LEDs of the battery show
nothing.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
Further information
For more information on operation, technology, batteries, environment and recycling, follow this link:
qr.hilti.com/manual?id=2306836 or scan the QR code at the end of this documentation.
Notice d'utilisation originale
1
Indications relatives à la documentation
1.1
À propos de cette documentation
•
Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
•
Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
•
Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
12
Français
Possible cause
The forward/reverse switch is in
the middle position.
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Electrical fault.
Battery defective.
Action to be taken
▶ Push the forward/reverse switch
to the left or right.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lug and push
the battery in until it engages.
Contact Hilti Service if the
problem persists.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Contact Hilti Service.
2306836
*2306836*
Publicité
