Abicor Binzel CR1000 Mode D'emploi page 35

CR1000/CR1250
11
10
9
8
7
1 Cooling unit
CR1000/CR1250 400 V
2 Coolant filler neck
Fig. 6 Components of the CR 1000/CR1250 400 V cooling unit
NOTICE
• To permanently monitor the correct functioning of the entire cooling system we recommend that you connect the active
flow control connector (11) to the power source.
 Fig. 7 Overview of the coolant circuit on page EN-10
• If the flow rate is too low, the flow control instigates the immediate switch-off of the connected devices and prevents
thermal overload.
NOTICE
• Dirt in the coolant can damage the cooling unit.
• Use the coolant filter (included) to prevent damage to the cooling unit.
 6.3 Before initially putting into operation on page EN-12
• ABICOR BINZEL does not accept any liability for damage caused when using the cooling unit without the
coolant filter.
BAL.0351.0 • 2020-06-10
1 2
3 Fuses
4
On/off switch
5 Coolant container with fill level indicator
5 Functional description
3
4
5
6
6 400 V plug 9 Coolant return (red)
7 10 Coolant supply (blue)
Coolant outlet neck
8 Coolant filter 11 Flow control connector
EN - 9