Power Source
This product is designed to operate on normal 120V 60Hz AC only. Attempting
tooperate this system from any other power source may cause damage to the
system,and such damage is not covered by your warranty.
NOTE:
You will note that this system is equipped with a polarized AC power
plughaving one blade wider than the other. This is a safety feature.
If this plug does not fit into your existing AC
outlet, do not try to defeat this safety
feature by filing the wide blade to make it fit
into your outlet. If this plug will not fit into
your outlet, you probably have an out-dated
non-polarized AC outlet. You should have
your outlet changed by a qualified licensed
electrician.
Protect Your Furniture
This model is equipped with non-skid rubber feet to prevent the product from
moving when you operate the controls. These
migrating rubber material specially formulated to avoid leaving any marks or
stains on your furniture. However certain types of oil based furniture polishes,
wood preservatives, or cleaning sprays may cause the rubber feet to soften,
and leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement centres everywhere,
and apply these pads to the bottom of the rubber feet before you place the
product on fine wooden furniture.
IMPORTANT: Raising And Lowering The Lid
To open the lid, raise it as far as it will go until the lid support bracket locks in
the open position.
To close the lid, lift it upward slightly until the lid support bracket unlocks , and
then gently lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID
CLOSED. ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT
BRACKET.
AC Plug
,
,
feet
are made from non-
,
7
AC Outlet
,
,
,