Publicité
Les langues disponibles
Les langues disponibles
SP6599-1 MoistAIR
3/29/06
Step 2. Location and Electrical Hook Up
WARNING: For your own safety, do
not use humidifier if any parts are
damaged or missing.
Selecting A Location
Place humidifier on a flat level surface,
take extra care in leveling when placing
the unit on carpet. Position the humidifier
where the most humidity is needed or
where the most air will be circulated
throughout the house such as near a
cold air return.
Moist air (humidity) produced will
disperse into the whole house, but the
area closest to the unit will have the
highest humidity. If the unit is positioned
close to a window, condensation may
form on the window pane. If this occurs
the unit should be repositioned in another
location.
NOTE: Due to release of cool, moist air
from humidifier, it is best to direct air
away from thermostat and hot air
registers and to position humidifier next
to an inside wall. Unit should not be
placed where cold air from outside walls
or warm air from a hot air register blows
directly on it.
Electrical Hook-Up
Locate nearest 120V A.C. wall socket in
the location desired, preferably on inside
wall. With the humidifier in the desired
location, route the electrical cord safely
so no one will trip or upset the humidifier.
Plug in the electrical cord.
WARNING: To reduce the risk of fire
or shock hazard, humidifier should
be plugged into a 120V A.C. outlet.
Do not use extension cords.
To reduce the risk of electrical shock,
this humidifier has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
1:13 PM
Page 5
All manuals and user guides at all-guides.com
Positioning The Unit
The humidifier should be positioned with
the back (cord exit side) and left side, at
least 2 inches (5 centimetres) away from
the wall. Air needs to enter through all of
the louvers in the housing assembly in
order for the humidifier to operate at peak
efficiency.
At least 2 inches
(5 cm) from wall
NOTE: Be sure that the humidistat, which
is located on the power cord, is free from
obstruction and away from any hot air
source.
If the plug does not fit fully in the outlet,
reverse plug. If it still does not fit, contact
a qualified electrician to install the proper
outlet. Do not change the plug in any
way.
5
Publicité
