Dynex WS-007 Guide De L'utilisateur page 8

8
Using your RF modulator
To use your RF modulator:
1 Make sure that you have connected your RF modulator to
your external device and TV.
2 Set your RF modulator's channel switch to channel 3 or 4.
3 Turn on your TV, then tune to the channel you set your RF
modulator to (either channel 3 or 4).
4 Turn on your external device.
5 Set the OHMS 75/1K switch on the back of your RF
modulator to the position that produces the best TV image.
When your RF modulator is receiving a signal from your
external device, the LED indicator on the front of your RF
modulator turns on.
6 To watch TV, turn off your external device.
Legal notices
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received,
including interference that may cause undesired operation.
Copyright
© 2006 Dynex. DYNEX and the DYNEX logo are trademarks of Best Buy
Enterprise Services, Inc. Other brands and product names are trademarks
or registered trademarks of their respective holders. Specifications and
features are subject to change without notice or obligation.
Using your RF modulator