Fitting The Cutting Head; Checking The Blades - Husqvarna R 120S Manuel D'utilisation

Fitting the cutting head

1 Place the belt under the stay of the cutting deck.
2 Make sure the lifting lever comes above the cutting deck
grip.
3 Fit the cutting deck's pipe together with the deck frame's
pipe.
4 Push the cutting deck in and make sure the guide bolts fit
into the grooves on the deck frame, one on each side.
5 Fit the cutting deck lock.
6 Grab the pipes and push the deck in.
7 Push the deck until you feel the pipes touch bottom.
24 –
English
Maintenance
8 Fit the belt according to the picture.
9 Tension the belt with the belt adjuster.
10 Fit the front cover.
11 Set the cutting height control to one of the positions 1-5

Checking the blades

To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades' attachment screws are tight.
• Put the unit in the service position, see Service position
for the cutting unit.
IMPORTANT INFORMATION
Replacing or sharpening the blades should be conducted
by an authorised service workshop.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the service centre assess
whether the blade can be sharpened or must be replaced.
!
WARNING! Do not use blades that are
cracked, chipped, or otherwise show signs
of damage or severe wear. Replace the
blades. The risk increases if the blades are
poorly balanced.