Orbegozo RA 1000 E Manuel D'instructions page 13

RA 1000 E
PARTS DESCRIPTION
A. Thermostat
B. Power setting switch
C. Cord storage
D. Castors
E. Big curved support
F. Small curved support
ASSEMBLY
The oil radiator is packed with the wheels not assembled. Please make sure that they are right
assembled before turning the device on.
Remove the heater and all the accessories from the carton.
1- Turn the radiator upside down carefully and place it over a carpet or any other soft surface in order
not to damage the unit.
2- Pass the "U bolt" in between the last and next-to-last fin and make it fit the holes of the small
curved support. Screw the U bolt to the small curved support with the help of the wing nuts. Then,
screw the wheels to the support. See picture below.
3- Repeat step 2 in between the first and the second fin, using the big curved support.
4- Turn the heater the right way up. The unit should be as shown in the picture in "parts description"
section.
USING THE THERMOSTAT AND POWER SWITCHES
1. Room temperature can be adjusted using the thermostat. Simply turn the thermostat knob
clockwise, to increase the heat, and anti-clockwise to decrease the temperature, until you reach the
desired temperature.
2. Switch the heater to one of the following power settings:
a. Push switch one and the power will be 500W/600W (for RA 1000 E and RA 1500 E respectively).
13