Fanelite FS-45RY Mode D'emploi page 24

3. Position the motor block on the tube and tighten the body locking
thumb screw to secure the assembly.
4. Unscrew and remove the blade's locking nut from the motor shaft by
turning it clockwise. Unscrew and remove the lock ring of the rear grill
from the motor by rotating it counterclockwise.
5. Place the rear grill on the motor shaft, then screw the lock ring of the
rear grill by turning it clockwise to fix the rear grill.
6. Place the blade on the motor shaft until it locks in place. Then tighten
the blade's locking nut by turning it counterclockwise. Take care to
tighten the nut properly. Check that the blade rotates well by turning it
manually.
7. Place the front grill on the rear grill (put the Fanelite logo
horizontally) and assemble the grills using the grills locking circle by
tightening the nut and the screw. Take care to tighten the screw
properly for optimum safety.
5. OPERATING INSTRUCTIONS
Before using your appliance, carefully read the safety instructions
in this manual.
Insert a battery AAA into the remote control (see section REPLACING
THE BATTERY for more information). Plug in the power cord.
Using the control panel or remote control :
Power ON/OFF
Press the ON/OFF button to turn on / turn off the fan.
Speed settings
Press the SPEED button to adjust the speed, 8 speeds. Each time the
button is pressed the speed will increase of one level. The
corresponding speed is displayed on the control panel.
1 : low speed .... 4 : medium speed ... 8 : high speed
24