How To Clean - Royalty Line EIP-2000.1 Mode D'emploi

How to Clean

1. Disconnect plug and wait until the unit is cooled down
completely. Cleanafter using every time.
2. If the pot/pan is used without being cleaned,discoloration or
cooked on stains may be caused.
3. Do not use benzine,thinner,scrubbing brush or polishing
powder to clean the induction cooker.
4. Wipe using dish washing agent and damp cloth.
5. Use vacuum cleaner to suck up dirt from the air intake and
exhaust vent.
6. Never run water over the unit(Water gets inside may cause
malfunction).
Trouble Shooting
Trouble Code
E0
E1
E2
E3
E4
E5
Possible Reasons
There is no pot/pan or
unsuitable pot/pan on
induction cooker.
Supply voltage is too
low(less than 85V)
Supply voltage is too
high(more than 275V)
Plate surface temperature
sensor is not connected well,
or short-circuited.
Please check it after one minute
The Heat sensor of radiator
(IGBT) is notconnected well,
or short-circuited.
Please check it after one minute
The temperature of plate
surface is too high
(more than 280℃）
Solution
Change the suitable
pot/pan,or contact the
qualified service center
Check power supply.
Power on after power
supply is back to normal.
Check power supply.
Power on after power
supply is back to normal.
Please contact the
supplier or qualified
service center.
Please contact the
supplier or qualified
service center.
Please wait for some minutes
until the unit cools down.
Please check pot/pan.