Publicité
Les langues disponibles
Les langues disponibles
Dry Ironing
• Set the steam regulator to the "O" position and turn the temperature regulator to the desired position. The Spray and Steam
functions may be used if required.
Steam Ironing
Unplug the iron from the mains supply. Turn the steam regulator to the "0" position, open the lid on the filling spout and fi ll the
tank with water.
Plug the iron into the mains supply and select a suitable temperature. The pilot lamp will stay lit while the iron is heating up and
go out as soon as it has reached the selected temperature.
As soon as the steam iron is hot, turn the steam regulator to (O) position. You can always regulate the amount of the steam by
turning the steam selector between (O) and (MAX).
When ironing with steam, make sure that the temperature control is always between the (••) and (•••) Max settings.
When using the steam iron for the first time, try it away from the clothes just in case there is any dirt in the steam chamber.
When you have finished ironing, set the steam regulator to the "0" position and empty the tank.
Spraying methods
You can get an additional burst of spray, whether ironing dry or with steam, in the following way:
Press the spray button. Do not use the spray for ironing silk as this may leave water marks.
Burst of Steam
Just as with the Spray function you can also get an additional burst of steam when ironing with or without steam by doing the
following:
Set the temperature regulator between the (••) and (•••) Max settings and wait until the iron reaches temperature.
Raise the iron slightly up off the material and press the super steam button down firmly.
Pause for at least 5 seconds between each jet of steam.
Instructions for use
English
5
Publicité
