Publicité
Les langues disponibles
Les langues disponibles
4. WALL MOUNTING
WARNING : The fixing must be made securely in the wall STRUCTURE by a qualified person. We can
not be held liable in the event of a fall of the appliance.
Mount the fan to the wall with screws and dowels appropriate to the wall structure :
1. Position the fan at the desired location and mark the positions of each screw (at the bottom and in the
center of each notch).
2. Remove the fan, pre-drill the wall and insert the screws and dowels.
3. Leave approximately 1.5 cm of each screw out of the wall.
4. Position the fan by inserting the screws into the notches and lower the fan so that the screws block to the
top of the notches.
5. Tighten the screws securely. Be sure to tighten securely for optimum safety.
5. OPERATION INSTRUCTIONS
WARNING : Use only with proper voltage and on a flat, dry surface. During use, do not insert your
hands or objects into the safety grill.
Plug in the power cord.
ON/OFF and speed settings
Use the switch or pull string to turn ON or OFF the fan and adjust the speed.
Low speed
Oscillation
To activate or deactivate the oscillation, use the oscillation's pull string.
Notes
To adjust the tilt of the head, stop the fan first and then loosen the tilt adjustment nut. Adjust the head to the
desired position and retighten the nut securely.
If you are not going to use your fan for a long time, we advise you to disconnect the appliance from the AC
power.
Medium speed
High speed
0 OFF
Publicité
