en-us_main.book.book Page 20 Wednesday, January 4, 2023 10:03 AM
20 INSTALLATION
Assembling the Left Refrigerator
Door
CAUTION
• Install the left refrigerator door after the right
door is installed.
NOTE
• The number of wire harnesses may vary
depending on the model.
1
Make sure that the plastic sleeve is inserted in
the bottom of the door. Install the refrigerator
door onto the middle hinge.
2
Fit the hinge
over the hinge lever latch
a
and slot it into place. Rotate the lever
clockwise and fasten the hinge.
3
Connect all the wire harnesses and the
ground screw.
4
Push the water supply tube into the hole on
the top case and pull it through the backplate.
5
Hold the water supply connection and gently
push in the collet
supply line as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tube in place.
• Connections may vary by model.
† This feature is only available on some
models.
†
Type A
b
†
Type B
c
†
Type C
NOTE
• Disassembling/Assembling the Water Lines
Collet
Tube
e
f
to connect the water
d
Insert line
Clip
g
h