Publicité
Les langues disponibles
Les langues disponibles
user's instructions
(3) to remove calcium deposits.
use - Placing the water tank
Make sure the water tank is placed correctly. Press it downwards with the help of the 'wings' on the side, so
the tank becomes lodged in its notch
use - dry ironing
1. Insert the plug (13) into the wall socket.
2. Turn on the main on/off switch (11) by switching it to position 1. The pilot light turns on.
3. Turn the iron temperature control dial (2) to the desired position (see the table in 'Ironing instructions').
The pilot light (9) turns on.
4. Place the iron in a vertical position (upright) and wait until the pilot light (9) goes out. The iron is now
ready to iron.
Iron the fabric by sliding the iron over the fabric. While you are ironing, the heating element will automatically
switch on and off to keep the soleplate at the set temperature. The pilot light (9) will, therefore, also turn on
and off automatically.
5. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by switching
it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and allow it to
cool down.
use - steam ironing
1. Fill the water tank (see 'Filling the water reservoir').
2. Insert the plug (13) into the wall socket.
3. Turn on the main on/off switch (11) by switching it to position 1. The pilot light turns on.
4. Turn the boiler temperature control (12) to MAX. The pilot light (10) turns on.
5. Turn the iron temperature control dial (2) to the desired position (see the table in 'Ironing instructions').
The pilot light (9) turns on. The iron will be ready for use when the pilot light goes out and the temperature
is reached.
6. When both pilot light go out, you can start steam ironing.
•
When the steam pilot light (10) lits, you must wait until the boiler has built up sufficient steam pressure
again.
•
The steam spray of this product can only be smooth after pressing the steam iron button for several
times.
•
Leave the device steaming (for ca. 20 sec) before every use by pushing the steam release button (3)
to remove calcium deposits.
7. After use, rotate the iron temperature control to the 0 position, turn off the main on/ off switch by switching
it to position 0. Remove the plug from the wall socket. Place the iron in a vertical position and allow it to
cool down.
If the temperature is too low, drops of water can escape with the steam. This can cause stains. If this
does happen, you should turn the temperaturecontrol dial to the recommended position. Never iron
32
Publicité
