Publicité
Les langues disponibles
Les langues disponibles
making use of old electrical equipment will make an important contribution to the protection of the
environment.
•
Contact your municipality for the address of the appropriate collection point in your neighbourhood.
5
6
8
7
oPerAtion - General
The appliance is intended only for domestic use, not for professional use.
1. Electricity and steam cable
2. Iron temperature control
3. Steam release button
4. Iron
5. Sole plate
6. Heat resistant non slip tray for the iron
7. Removable water tank
use - before first use
Before using the iron for the first time, begin by ironing a piece of old fabric to ensure that the soleplate and
water reservoir are clean. Repeat this when the iron has not been used for a period of time. The appliance
may emit a little smoke and a characteristic smell when you switch it on for the first time. This is normal, and
will soon stop. Make sure the appliance has sufficient ventilation
use - filling the water reservoir
1.
The appliance can be filled with water before and during use. You can do that by opening the water tank
lid (8) and using the supplied measuring cup. You can also take out the water tank (7), fill under the tap
and then reinstall it.
2.
Fill the water tank with a maximum of 0.8 litres of clean tap water.
•
Never fill by holding the complete appliance under a running tap. There is a good chance that water
will flow over the casing and into the appliance.
•
If you live in an area with hard water, it is recommended to use distilled or demineralized water.
•
Never add a stain remover or other additives to the water.
•
Leave the device steaming ( for ca. 20 sec) before every use by pushing the steam release button
1
2
4
9
3
8. Water tank lid
9. Pilot light (iron warming up)
10. Pilot light (building up pressure)
11. Main on/off switch with pilot light
12. Boiler temperature control
13. Power cord and plug
31
user's instructions
11
10
12
13
Publicité
