Steba TO 10 Mode D'emploi page 10

∙
Attention! Device gets hot. Danger of burns!
Touchable surfaces will be hot during operation! Place
the device on a flat and insensitive surface with and
keep a distance of at least 70cm to burnable materials.
∙ If an extension cable is used, it has to have a cross-section of
1,5mm²
∙ If a GS-tested 16 A multi-pin extension is used, it may not be
charged with more than 3680 watts due to fire hazard.
∙ Make sure that children do not tease the cable or that a trip
hazard occurs.
∙ The device must always be disconnected from the power supply
if it is not supervised and before assembling, disassembling or
cleaning.
∙ Hygiene: Please always clean the device to avoid bacteria and
mould formation.
Cleaning
∙
Attention! Pull the plug before cleaning and allow
the device to cool down.
∙ Never immerse the unit into water.
∙ Crumbs must be removed for hygienic reasons and the danger
of fire.
∙ The crumb tray can be pulled out of the device. After cleaning,
the crumb tray must be reinserted into the device.
∙ Do not use abrasives, oven spray or solvents.
∙ Clean the housing with a damp cloth with detergent and dry.
Workplace
Important:
Never place this device on or next to hot surfaces (e.g. hot stoves).
Only use it on a even, stable and a heat resisting surface. It is im-
portant that no inflammable items are near to the device. Do not
place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.
10