Publicité
Les langues disponibles
Les langues disponibles
Once the device is plugged to a wall outlet, to adjust the time at which you want the coffee maker to
start preparing the coffee:
1. Press the "PROG" (programming) button twice. The word "TIMER" will appear in the top
left of the screen.
2. Press the "HEURE" button as many times as necessary in order to settle the required
hour.
3. Wait for a few seconds until the screen shows the current time.
4. Prepare the water reservoir and the coffee.
5. Press the "M/A" (On/Off) button twice. The blue "PROG" indicator light switches on. The
coffee maker will start at the programmed time.
6. After preparing the coffee, if you leave the coffee maker on, it will turn off at the end of
5 minutes max. If you want to switch it off immediately, press the "M/A" (On/Off) button
to switch off the coffee maker.
N.B.:
-
To cancel your programme, press the "M/A" (On/Off) button. The blue "PROG" indicator light
switches off.
-
In the event of a power failure or if you unplug the device, your programme will not be
saved.
-
You can schedule a deferred start of up to 24 hours
4. Maintenance
1. Disconnect the coffee maker and leave to cool down before cleaning.
2. Open the lid and remove the filter holder in order to empty out the grounds from the
permanent filter.
3. You can wipe the outer and inner surfaces with a slightly damp sponge or soft cloth.
4. Clean the removable parts with hot soapy water, then rinse with clear water and dry
thoroughly.
5. Take care to handle the permanent filter gently while also rinsing it with clear water.
6. Do not clean with alcohol or detergents. Never immerse the appliance in water or any
other liquid.
5. Descaling
1. In order to keep your device in good condition, it is necessary to descale it every 3 months or
according to the hardness of the water and the frequency of use.
2. To clean the appliance, put 1 part of vinegar and 3 parts of water in the reservoir without
adding any ground coffee and switch the coffee maker on.
3. Repeat until the coffee maker is clean.
4. Then, run the coffee maker 2 to 3 times without coffee in order to rinse it thoroughly.
6. TREATMENT OF THE ELECTRIC AND ELECTRONIC
APPLIANCES AT THE END OF LIFE
.
Publicité
