Publicité
Les langues disponibles
Les langues disponibles
10
10D
10B
10 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (10A) through Hose Guide (10C). From underneath sink, push
Quick Connect Housing (10B), located on the end of the Spray Hose (10A), firmly upward
onto the receiving Tube (10D), until unable to push any further. Pull down on the quick
connect housing (10B). If the housing and the Inner Collet (10E) separate slightly, but
does not pull off the receiving Tube (10D), quick connect is secure.
When installing without side spray, a Plug (10F) 972-044 must be used and is to be
ordered separately.
STOP
11
11D
11 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Deck Plate (11A). Insert Hose Guide (11B) into Hose Guide Flange (11C) and
onto the sink hole. Insert the faucet Supply Tubes (11D) through the center hole of the
sink. Insert faucet Shanks (11E) through the end holes of the sink.
10C
10E
10B
10B
OPTIONAL
10A
(Must be ordered
separately)
Go To Step 17
11A
11E
11E
11B
11C
ENGLISH
12
12A
10D
10F
12 SECURING FAUCET TO DECK
From underneath sink, hand tighten Wing Nuts (12A) to Mounting Posts (12B), secure
Hose Guide (12C) by screwing Plastic Locknuts (12D). Hand tighten. Remove any
excess putty from around the outside edge of Deck Plate (12E). Secure the faucet by
placing the Metal Washer (12F) and the Long Nut (
(12H). Make sure that the bumps on the Metal Washer (12F) are facing up. Tighten until
the faucet is firmly connected to the sink. Do not over tighten!
13
13D
13B
13 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (13A) through Hose Guide (13C). From underneath sink, push
Quick Connect Housing (13B), located on the end of the Spray Hose (13A), firmly upward
onto the receiving Tube (13D), until unable to push any further. Pull down on the quick
connect housing (13B). If the housing and the Inner Collet (13E) separate slightly, but
do not pull off the receiving Tube (13D), quick connect is secure.
When installing without side spray, a Plug (13F) 972-044 must be used and is to be
ordered separately.
4
12B
12H
12F
12A
12G
7
/
16
13E
13B
13B
STOP
Go To Step 17
12E
12B
12C
12D
Hex.) (12G) onto the Mounting Post
13D
13C
13F
OPTIONAL
(Must be ordered
separately)
13A
Publicité
