Publicité
Les langues disponibles
Les langues disponibles
6
6A
6B
6 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Deck Plate (6A). Insert the faucet Supply Tubes (6B) through the center hole
of the sink. Insert faucet Shanks (6C) through the end holes of the sink.
7
7C
7A
7D
7E
7 SECURING FAUCET TO DECK
From underneath sink, hand tighten Wing Nuts (7A) to Mounting Posts (7C). Remove
any excess putty from around the outside edge of Deck Plate (7B). Secure the faucet by
placing the Metal Washer (7D) and the Long Nut (
(7F). Make sure that the bumps on the Metal Washer (7D) are facing up. Tighten until the
faucet is firmly connected to the sink. Do not over tighten!
STOP
ENGLISH
6C
7B
7F
7C
7A
7
Hex.) (7E) onto the Mounting Post
/
16
Go To Step 17
8
8D
8E
8A
8 FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Deck Plate (8A). Insert Hose Guide (8D) into the Side Hole (8E) in the Deck
Plate (8A). Align the hose guide Tabs to those in the Deck Plate Hole. Insert the faucet
Supply Tubes (8B) through the center hole of the sink. Insert faucet Shank (8C) and
Hose Guide (8D) through the end holes of the sink.
9
9A
9B
9G
9 SECURING FAUCET TO DECK
From underneath sink, secure the Hose Guide (9A) by screwing the Plastic Locknut
(9B). Secure Deck Plate (9C) by screwing Wing Nut (9D) to Mounting Post (9E). Hand
tighten. Remove any excess putty from around the outside edge of Deck Plate (9C).
Secure faucet by placing the Metal Washer (9F) and the Long Nut (
Mounting Post (9H). Make sure that the bumps on the Metal Washer (9F) are facing up.
Tighten until the faucet is firmly connected to the sink. Do not over tighten!
3
8A
8D
8C
8B
9C
9H
9E
7D
9F
7
/
Hex.) (9G) onto
16
Publicité
