Publicité
Les langues disponibles
Les langues disponibles
4. ▼Button: This button will decrease the displayed value in the LCD display.
5. Power Output: Totally four out sockets.
6. Green LED Indicators: Indicators will illuminate when corresponding channel
activated.
7. LCD Display: This multifunction display is a monitor for setting or running the unit
8. Channel Fuses: Each of the four channels is protected by a 6.3A fuse. These
fuses prevent unit from overloading and damaging. Be sure to always replace
them with the exact same type fuses.
9. Power Switch: This switch controls the unit's main power.
10. Power Cord: Plug this cord into a rated main power supply for your area.
11. DMX Input: This connector allows the input of DMX control signal.
12. DMX Output: This connector allows the output of DMX control signal to the next DMX
device.
OPERATION
The unit has two switchable working modes. It can be used as a four-
channel chaser or as a 1, 2, or 4 channel DMX dimmer pack. Please
follow up the instructions below to operate the unit for your desired
performance.
CHASE MODE
Choose this working mode only when you want the device to act as a 4-
channel chaser. This device has 16 built-in programs. You can select to
run any of these programs specifically, or set the unit to chase in a
random sequence among all 16 built-in programs for a more dramatic
show effect. The chase speed can also be adjusted.
1. Connect your lighting fixture to any of the four power sockets on the
pack.
2. Use the mode button to select chase mode: Chase mode is indicated
in LCD display as "PA" followed by numbers 01-16. "PA" stands for
Program Applied. If an "A" appears in the LCD display, you are in
DMX mode, "A" stands for address.
3. Set you desired chase pattern: Once you have selected the chase
function, use the MENU button to select your desired chase. The
chase pattern is represented in the LCD display by "P" followed by
two numbers. You may select any of the 16 built-in programs to run
at a single time.
4. Set you desired chase speed: At this point you may change the
program chase speed. While in chase mode, tap on the MENU
button until the "SP" followed by two numbers is displayed in the
LCD. Then use the ▲and ▼ buttons to adjust the chase speed. A
value of 99 will give you the fastest chase speed (about one step per
8/4
Publicité
