Greencut GSC1700C Manuel D'utilisation page 50

50
PRODUCT USE
ATTENTION: To avoid injury from accidental starts, always turn off the machine and disconnect it
from the power supply before moving it or making adjustments.
START UP
ATTENTION: Be sure to use an extension cable suitable for outdoor use (H05VV-F 2X0.75mm2)
attached to the power supply through a leakage protection system (RCD).
1. Connect the machine to the extension cable and then to the power supply.
STARTING AND STOPPING
1. Press and hold the safety lock button on the switch box.
2. Pull the switch lever upwards towards the handle and hold it in this position to start the engine.
3. Release the safety lock button.
4. To stop the machine, release the switch lever.
WORKING DEPTH ADJUSTMENTS
To adjust the working depth you can select between two levels LOW or HIGH.
• When you turn the adjustment wheel to the LOW level, the working depth will be greater up to a depth of
-11mm. Use a medium-low level to remove moss and weeds from the lawn.
• When you turn the wheel to the HIGH level, the working depth will be less, up to a maximum of 5mm. Use this
level to remove grass clippings.
Lock button
Adjusting knob
1