oneConcept Streamo Mode D'emploi page 68

All manuals and user guides at all-guides.com
EN
CD PLAYBACK
CD/MP3 OPERATION
Press Menu button on the Device or on the remote control to select CD
mode.
Open the CD door by press the top cap.
Insert a CD disc into the CD compartment .
PLAY/PAUSE operation
Press Enter button on the device or button on the remote control to start
play.
Press Enter button on the device or button on the remote control to Pause .
Press button on the device or on the remote control to stop play .
Press or  to skip backward or forward to the desired track .

Rotary the knob on the device or press or  button on the remote

control to skip backward or forward to the desired track
BT
Selecting an audio source: Press [ENTER] (4) repeatedly until "BT" appears
on the display.
Make sure that no other BT device is connected to the radio. "No
Connection "will appear on the display.
Activate BT mode on the device that you want to connect. Look for
The radio on the list of detected devices on the BT device (refer to the
instruction manual of the device). Once the devices have found each other,
the radio will appear as 'Streamo' on the BT device.
Select 'Streamo' from the list. If you are required to enter a PIN code, enter
0000 (four zeros). Certain devices may also require you to approve the
connection.
Once the connection has been successful, "Connected" will appear on the
display of the radio.
Start playback on your BT device.
Control the playback from the BT device or from the radio using the Vol+/
Vol- on the device and remote control, Adjust the volume both on the BT
device and the radio.
To disconnect a connected BT device: Press and hold down the Enter button
for 3 seconds. The message "No Connection" will appear on the display.
68