Publicité
Les langues disponibles
Les langues disponibles
HANDLE INSTALLATION AND ENERGY SAVING TIPS
Handle Installation
1. Remove the handle, (2) screws, and
from the bag shipped inside the cabinet.
2. Locate handle opposite the hinges and secure in place
using the (2) screws and the allen wrench.
(See Figure 7).
Figure 7
Right hand hinged
door shown
⁄
" allen wrench
5
32
Screws
Handle
The following suggestions will minimize the
cost of operating your refrigeration appliance.
1. Do not install your cold appliance next to a hot appli-
ance, (ovens, glassware washers, etc.). heating air
duct, or other heat sources.
2. Install product out of direct sunlight.
3. Ensure the toe grille vents at front of unit beneath door
are not obstructed and kept clean to allow ventilation
for the refrigeration system to expel heat.
4. Plug your appliance into a dedicated power circuit. (Not
shared with other appliances).
5. When initially loading your new product, or whenever
large quantities of warm contents are placed within
refrigerated storage compartment, minimize door
openings for the next 12 hours to allow contents to pull
down to compartment set temperature.
6. Maintaining a relatively full storage compartment will
require less appliance run time than an empty compart-
ment.
7. Ensure door closing is not obstructed by contents
stored in your appliance.
8. Allow hot items to reach room temperature before plac-
ing in product.
9. Minimize door openings and duration of door openings.
10. Use the warmest temperature control set-temperature
that provides the proper storage for your stored con-
tents.
11. Set the control to the "off" position if cleaning the unit
requires the door to be open for an extended period of
time.
12. Periodically clean the front grille (toe kick), see page 4.
6
Publicité
