EGAmaster 57669 Mode D'emploi page 10

Order and Cleanliness
he machine must have its own minimum accessory elements. Use a cotton cloth to clean it
and in case of dirt, slightly moistened with soapy water.
Identification plate present and legible
Model, manufacturer, serial number, manufacturing date.
Wear
- There should be no strange noises in the movements.
- The swing structure must rotate flat, without pitching.
- The crank should turn between stops smoothly and without squeaks.
- The safety cover must be integral and close properly.
Mechanical maintenance
The spindle SYSTEM should be cleaned with a clean and greased cloth in case of detecting
noise or resistance, although it probably never needs to be lubricated. The shaft does not
require greasing.
Deformation
There should be no permanent deformation or CRACKS.
Corrosion
There can be no corrosion. It is a machine for office use in a dry environment.
If in doubt, contact the manufacturer for review and maintenance.
- DO NOT use this machine for tests that do not correspond to its intended use.
- DO NOT use the machine if you doubt its condition.
- DO NOT violate the safety protections or use the machine without them being active.
- DO NOT overload the machine or the sensors. Take into account the ranges of the sensors.
10
THE FOLLOWING POINTS MUST BE VERIFIED
REASONABLY FORESEEABLE MISUSE