SPORTSTECH X100-C Manuel page 29

Step 3
Attach the handlebars with the two
(B) screws and washers on the main frame.
B
Tighten these tightly with the Allen key without
using too much force. Connect the pulse cable
to the pulse connector and the sensor cable
to the sensor connector on the back of the
monitor.
Then slide the monitor onto the bracket in the
middle of the handlebar.
Step 4
Remove the three pre-installed screws and
nuts on the underside of the seat cushion and
set them aside. Align the seat on the triangle
bracket forwards. Screw the bolts with the nuts
A
through the underside of the triangular bracket
back into the seat and tighten them.
EN
Then align the backrest with the holes in the top
of the backrest support and attach the back-
rest to the backrest support with two (A) screws.
Step 5
Insert the seat post into the main frame and
secure it with the height adjustment knob.
To fix the left and right pedals with straps you
can first distinguish the pedals and straps by
the markings " L " (left) and " R " (right). When
assembling the pedal straps, place the short
end on the inside.
29