Benninca BOB21M Mode D'emploi page 21

BOB
• Do not stand in the movement area of the gate.
• Do not let children play with controls and near the gate.
• Should operating faults occur, do not attempt to repair the fault but call a qualified technician.
In the event of a power cut or breakdown, proceed as follows to operate the wings manually (refer to figures A,B,C):
• Open the protective door of the release mechanism (fig. A).
• Insert the special release key supplied and turn it through 90°, as indicated in fig. B for a right actuator or as indicated
in fig. C for a left actuator.
• It is now possible to open/close the wing manually.
• To restore automatic operation, return the release key to its initial position.
• Remove the release lever and close the protective door.
• Every month check the good operation of the emergency manual release.
• It is mandatory not to carry out extraordinary maintenance or repairs as accidents may be caused.These operations
must be carried out by qualified personnel only.
• The operator is maintenance free but it is necessary to check periodically if the safety devices and the other compo-
nents of the automation system work properly. Wear and tear of some components could cause dangers.
As indicated by the symbol shown, it is forbidden to dispose this product as normal urban waste as some
parts might be harmful for environment and human health, if they are disposed of incorrectly. Therefore,
the device should be disposed in special collection platforms or given back to the reseller if a new and
similar device is purchased. An incorrect disposal of the device will result in fines applied to the user, as
provided for by regulations in force.
All Benincá products are covered by insurance policy for any possible damages to objects and persons caused by con-
struction faults under condition that the entire system be marked CE and only Benincá parts be used.
Fig.A
S
User's handbook
Safety rules
Manual and emergency manoeuvre
Maintenance
Waste disposal
Warning
Fig.B
L
Fig.C
L
21