Publicité
Les langues disponibles
Les langues disponibles
Attach Handle to OD4800:
The OD4800 manual punch is shipped with the handle removed from
u
the punch. You will need two 3/8" wrenches (not supplied) to tighten
the handle bolt.
?
Locate the handle and remove the nut, washer and bolt from the
handle.
Orientate the handle so the black handle grip extends to the right of
the machine as seen on front cover of this book.
?
Slide handle onto exposed crankshaft of machine and align the holes
in the handle with the hole in the crankshaft.
Insert the bolt completely through the handle and install the washer
and nylock nut. See photo below left.
Tighten the nut securely so there is not play between the handle and
the crankshaft.
?
Open the top grey lid of the punch and remove the styrofoam block.
See photo below right.
Front of
Machine
Bolt
Handle
Crankshaft
Diagram 1 (Image of OD4800)
Remove Styrofoam
6
Publicité
