Rhin-O-Tuff OD4012 Manuel D'instructions page 12

Setting the paper stop/guide:
OD4012, OD4000 and OD4800 -
u
Locate the paper stop on the front cover of
u
the machine. Loosen the knob
counterclockwise, so that the guide can be
adjusted to the left or the right.
paper stop until the desired position is
reached and tighten the knob clockwise
until tight to lock the paper stop in place.
Repeat this procedure
pattern is centered on the paper.
The OD4012, OD4000 and OD4800 punch machines allow for
viewing of the common size paper position markings on the die
assemblies. Aligning the paper stop with these marks will result
in the punch pattern being centered on the paper and need only
small adjustments if at all.
Punching Paper:
Select an appropriate number of sheets to be punched and slide the
u
sheets down vertically into the opening of the die assembly. When the
paper is fully inserted, slide it to the left so it comes in contact with the
paper stop. Make sure all the edges of the sheets are flush by tapping
the top and the right hand sides of the sheets then activate the punch
by depressing the foot-pedal. OD4800 users pull handle toward front
of machine.
If a paper activated switch is being used, tap the sheets flush
before sliding the paper to the paper stop.
Removing Paper Waste:
The paper waste drawer is located conveniently on the front of the
u
punch. The paper waste drawer is removed by lifting up on the front
and pulling out away from the machine. This drawer should be
checked frequently while punching and emptied as necessary.
Move the
until the punch
10
Paper Stop