Husqvarna PW 240 Manuel D'utilisation page 15

4. Remove the garden hose adapter in the opposite
sequence.
To install the support and the holder for
the spray handle and the spray lance
1. Put the support (A) in position and install the screw
(B). (Fig. 16)
2. Put the holder (C) in position and install the 2 screws
(D).
Note:
The lower screw on the holder also holds
the support. Make sure that you align the hole in the
support with the lower screw.
Introduction
WARNING:
safety chapter before you use the product.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
To unfold and fold the transport handle
• To unfold the transport handle, push the buttons
on the left and right side and pull up the transport
handle. (Fig. 18)
• To fold the transport handle, push the buttons on
the left and right side and push down the transport
handle. (Fig. 19)
To install the spray handle
1. Pull out the high-pressure water hose. (Fig. 20)
2. Hold the spray handle tightly with one hand and
push the high-pressure water hose into the quick
connection on the spray handle. (Fig. 21)
1855 - 008 - 02.05.2023
Operation
Read and understand the
To install the wheels
Note:
Before you do this procedure, make sure that
the support and the holder for the spray handle and
spray lance are installed. Refer to
and the holder for the spray handle and the spray lance
on page 15 .
• Put the wheel assemblies in position and install the 2
screws. (Fig. 17)
To remove the spray handle
1. Push the tab in the direction of the quick connection
on the spray handle and pull out the high-pressure
water hose. (Fig. 22)
2. Turn the hose reel clockwise until the high-pressure
water hose is fully wound. (Fig. 23)
To install the spray lance
1. Hold the spray handle with one hand and push the
coupling on the spray lance into the spray handle.
(Fig. 24)
2. Turn the spray lance clockwise and release the
spray lance. The spray lance locks in position.
To remove the spray lance
1. Push in the spray lance and turn it counterclockwise.
(Fig. 25)
2. Pull out the spray lance from the spray handle.
To install and remove a nozzle
The product is supplied with 2 nozzles: 1 nozzle with
a straight water jet (identified with "gentle nozzle") and
1 rough nozzle with a rotating water jet (identified with
"rough nozzle". The nozzle with a straight water jet
can be used to clean sensitive surfaces, for example
vehicles. The nozzle can be used to clean surfaces that
are not sensitive, for example driveways.
(Fig. 26)
CAUTION:
a rotating water jet on sensitive surfaces, for
example painted surfaces on a vehicle. The
rotating water jet can cause damage to the
surface.
• To install a nozzle, hold the spray lance with one
hand and push in the nozzle until it locks in position.
(Fig. 27)
To install the support
Do not use the nozzle with
15