HOGERT HT8G613 Mode D'emploi page 4

• The charger control is placed on the panel for easy operation.
• The chargers have a 9-function diagnostic, protection and recovery program which is fully automatic when the connected battery requires
it. This feature extends battery life.
• Battery regeneration - the device detects sulfation and uses pulsed current and voltage to remove sulfate from the battery plates, restoring
its capacity.
• Automatic switch-off - after charging, the device switches to maintenance mode, which protects the battery against overcharging.
• Short-circuit protection - in case of improper connection of the clamps or changing the polarity, the indicator lights up, and the device
protects the vehicle's electronic systems and does not cause sparks.
• Overheating protection - in the event of excessive heating of the device, the charging current is automatically reduced or it is completely
suspended until the device cools down. Charging will restart automatically.
CONNECTING
• Make sure that the mains voltage is single-phase, 230V, 50Hz.
• Connect the positive terminal of the battery to the cable (+ red) of the charger.
• Connect the negative terminal of the battery to the cable (- black) of the charger.
CHARGING
Press the mode button to select the charging mode according to the battery needs.
Charging will start automatically after a few seconds.
When charging is complete, the display will show „FULL" and the charger will switch to maintenance mode.
CURRENT Change of charge rate between 2A / 8A / 15A by pressing the button. Settings can be changed while charging.
BATTERY Change of the battery type between STD / AGM / CAL by pressing the button. Settings can be changed while
TYPE charging.
AMP After pressing, the actual AMP charge current will be displayed on the LCD screen.
VOLT After pressing, the actual V charge voltage will be displayed on the LCD screen.
The button starts the repair (desulphurisation) process of the battery. If repair is impossible, the icon will
RECON
appear on the display
• Battery charge status indicator.
• No connection
• Loose connection
• Reverse polarity
• Check if the terminals are properly and correctly connected.
The battery is in poor condition and it may need to be replaced.
• High voltage:
You can choose the wrong voltage, for example, you can charge 12V battery in 6V mode or 24V battery in 12V
mode.
High temperature
MAIN TECHNICAL SPECIFICATIONS
Input voltage
Frequency
Charger type
Output current
Rated output voltage:
Battery types
IP rating
With minimal maintenance, this battery charger will provide years of reliable service. Follow these simple steps to keep the charger
in optimal condition: Clean the charger terminals after each use - all fluids and grease should be removed. Clean outer casing of the charger
with a soft cloth and mild soap solution if necessary. Keep charger cables loosely coiled during storage to prevent damage.
4
. While the repair is in progress, the rest of the buttons do not work.
single-phase, 230VAC±10%
12V lead-acid (WET, AMG, MF, CAL)
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland S.A., ul. Przejazdowa 21, 05-800 Pruszków, www.hoegert.com
50/60 Hz
9 function
2A/8A/15A
12V
IP 20