Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
ENGLISH
When disposing of batteries, follow
the instructions given in the section
"Protecting the environment".
Under extreme conditions, battery
leakage may occur. When you notice
liquid on the batteries, carefully wipe
the liquid off using a cloth. Avoid skin
contact.
In case of skin or eye contact, follow
the instructions below.
Warning! The battery fluid is a diluted
sulphuric acid and may cause personal
injury or damage to property. In case of skin
contact, immediately rinse with water. If
redness, pain or irritation occurs seek
medical attention. In case of eye contact,
rinse immediately with clean water and
seek immediate medical attention.
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your Black & Decker charger only to
charge the battery in the tool with which
it was supplied. Other batteries could
burst, causing personal injury and
damage.
Never attempt to charge non-
rechargeable batteries.
Have defective cords replaced
immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The battery must be placed in a well
ventilated area when charging.
DO NOT OVERCHARGE:
AC recharge up to 10 hours maximum.
After recharge, disconnect the
charging adapter and wait 5 minutes
before use.
The following symbols are found on
your charger:
Your charging base is double
insulated; therefore no earth
wire is required.
4
Fail-safe isolating
transformer. The mains
supply is electrically
separated from the
transformer output.
The charger automatically
o
130
C
shuts off if the ambient
temperature becomes too
high. As a consequence the
charger will be inoperable.
The charging base must be
disconnected from the mains
supply and taken to an
authorised service centre for
repair.
The charging base is intended
for indoor use only.
Electrical safety
This tool is double insulated;
therefore no earth wire is
required. Always check that
the power supply corresponds
to the voltage on the rating
plate.
If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the
following features:
1. Hook
2. LED light bar
3. Battery status LED
4. On/off/brightness switch
5. 12 Vdc charging socket
6. Mains charging adaptor
Charging the light bar (fig. A)
Make sure that the light bar is
switched off (the on/off/brightness
switch is in the 0 position).
Warning! Do not charge for longer than 10
hours.
Insert the charger jack plug (7) into the
12 Vdc charging socket (5).
Insert the mains charging adaptor (6)
into a mains power socket.
Publicité
