Diall MS8907 Manuel D'instructions page 14

EN Installing the Battery
NOTE: lf your detector does not work properly, check the batteries to
make sure they are still good and are properly inserted.
1. Open the battery cover (7) by simultaneously pressing the top of the
pocket slip (6) and sliding the battery cover (7) out.
2. Insert two AAA batteries (Ensure the correct polarity).
3. Replace the battery cover (7).
Operation
Checking the AC electrical voltage in a socket
WARNING: Risk of Electrocution. High-voltage circuits, both AC and
DC, are very dangerous and should be measured with great care.
WARNING: Risk of Electrocution. Before using to check for voltage in
a socket, always test the detector on a known live circuit to verify that
WARNING: Risk of Electrocution. Keep hands and fingers on the
18_s1_s11_5059340161730_DIALL_A6_IM_Multi_V04.indd 14
EN Use
WARNING: The measurement must be done only with
the cap on the probe tip.
the detector is working properly.
body of the detector and away from the probe tip.
WARNING: Test on known live circuit before use.
7
6
24-06-2021 17:19:40
14