washing a load of laundry
OVERVIEW OF THE CONTROL PANEL
1
Display panel
1
Air Wash button
2
Wash selection
3
button
Temperature
4
selection button
Rinse selection
5
button
Spin selection
6
button
Dry selection
7
button
Silver Wash
8
button
Stop&Add
9
selection button
Delay End
10
selection button
12_ Washing a load of laundry
WD7101CKW-02502D-03_EN.indd 12
All manuals and user guides at all-guides.com
2
3
4
5
6
Displays the remaining wash cycle time, all of washing information and error
messages.
Use to remove bad smells.
Selected in the sequence: Suit/Jumper Knit Coat Bedding Cancel
Use this to only perform washing or prewash.
Selected in the sequence: Main Wash Prewash + Main Wash Main
Wash.
The washing time cannot be adjusted (for the Cotton course).
Prewash can only be selected for Cotton, Intensive, Boil, Eco-Boil, Blanket
and Towel.
Selected in the sequence. : 30˚C 40˚C 60˚C 95˚C
The water temperature varies depending on the course.
Do not allow only hot water to be supplied.
Select this to add a rinse cycle or only perform the rinse cycle.
You can select this up to 5 times.
You can select the spin speed, if necessary.
If only the spin cycle is selected and Start/Pause is pressed in the middle of
the spin cycle, the machine starts spinning from the beginning.
The spin speed can vary, depending on the course.
No Spin means no spinning is performed after the drain.
Selected in the sequence: Cupboard Extra Iron Light Time (30min
1:00min 1:30min 2:00min 2:30min) Cupboard.
Silver water is supplied in the wash cycle as well as the last rinse, featuring
sterilization and antibacterial coating.
Select this to add the laundry amid the process.
Press the button repeatedly to cycle through the available delayed end
options (up to 24 hours maximum in one hour increments).
Displayed hours means the time of finished washing-cycle.
7
8
9
10
11
12
13
14
2008-08-22 ¿ÀÈÄ 7:11:54